Energy Efficient Copeland Scroll Compressors for Walk-ins

Save valuable resources with energy efficient Copeland Scroll compressors, permanent split capacitor motors and electronically commutated evaporator motors on your next refrigeration system purchase. Scroll condensing units are available for medium and low temperature refrigeration applications. The condensing units are optimized to work with HFC refrigerant R-404A, a reliable alternative to HCFC R-22. As the energy efficiency trend increases, the use of scroll compressors is a more important feature than ever before. Scroll compressors are inherently more reliable because they have significantly fewer moving parts and handle liquid slugs and debris more effectively. The scroll technology has only three moving parts, as compared to the standard hermetic compressors that have 150 plus moving parts. Scroll is effective in using less energy or amp draws verses the standard hermetic compressor. Copeland studies indicate that up to a 15% reduction in energy use is experienced for most applications. When adding the benefit of PSC motors on condensers and EC motors for evaporators, energy use will decrease. Sizing refrigeration equipment to operate for 14 to 16 hours instead of the traditional 16 to 18 hour run time will also save energy by using less kilowatts and costing less to operate compressors and motors.

Copeland Scroll Refrigeration Compressor

Read the rest of this entry »

Maintaining Your Walk-in Cooler or Freezer

Tips from U.S. Cooler for Maintaining Your Walk-in Cooler or Freezer.

How to keep your walk-in operating efficiently.

• Close door when not in use. Do not block or prop door open for extended periods of time. Make sure door is closed at all times except when entering and exiting the walk-in.
• Periodically, minimum of twice a year, clean evaporator and condensing coil. If located outside, the coils should be cleaned more often.
• Make sure fan motors are running at optimum speed.
• Clean fan blades to reduce drag.
• Make sure there is nothing stacked around the coil to restrict airflow.
• Occasionally have service technician check all electrical connections to make sure they are good and tight. Loose wires could cause high amperage, which will cause your unit to use more energy.
• Check for damage or decay in the insulation on suction lines between condensing unit and evaporator coil. Replace as needed.
• Check door sweep for tears and make sure sealing properly.
• Hinges should be lubricated once a year to keep closing properly.
• Make sure the lights are off when exiting the walk-in. Lights produce heat, which will cause your unit to run more to hold its optimal temperature.
• On outside condensing units, maintain clear and adequate airflow. For example, do not allow trash or weeds to accumulate around walk-in.
• Do not pile anything on top of the walk-in. This could cause damage to the ceiling panels.
• Periodically, check gaskets between panels to make sure they are not cracked or weathered. If so, check with your local health codes for the correct procedure to follow as far as repair and replacement.

How to keep your walk-in clean.

• 

  Do not use harsh detergents on metal surfaces.

  Soap and water is the best cleaning method for your walk-in. Do not use harsh chemicals as it may react and harm the metal surface of your walk-in.
  For chemicals not to use read this pdf.

• Minimum of twice a year use a self-rinsing cleaner, soap and water or stiff bristled brush to clean your evaporator and condensing coils.
• Drain lines – at least once a year, work with a service tech to make sure the drain lines are clean and not clogged with any debris.
• Door gaskets – Regularly wipe down with soap and water. If door gaskets are damaged, cracked or stiff magnet will not seal and will need to be replaced.
• Sweep or mop floors to make sure floors are kept clean. Read the rest of this entry »