Operating Cost for Walk-in Coolers and Freezers

Before purchasing your walk-in, you may be wondering how much it will cost to operate your walk-in.

To give you a rough estimate of how much it cost to operate a walk-in cooler or freezer, using the national average of 11.89 cents per kilowatt, look at the chart below.

*These numbers were figured using the $.0999 kilowatt hour cost. According to the Energy Information Administration this is the average cost in the United States for commercial electricity.

This chart was created using several assumptions that can affect your actual operating cost.

1. The type of insulation in the walk-in.
2. Efficiency of the refrigeration system.
3. Inside and outside temperature of walk-in.
4. Where the walk-in is located.
5. The temperature and the weight of the product entering the walk-in.
6. How often the door is opened.
7. The age of the walk-in.
8. Cost of electricity.

This is just to name a few.  If you would like to be more accurate using your electric rate, follow the instructions below. Read the rest of this entry »

Energy Efficient Copeland Scroll Compressors for Walk-ins

Save valuable resources with energy efficient Copeland Scroll compressors, permanent split capacitor motors and electronically commutated evaporator motors on your next refrigeration system purchase. Scroll condensing units are available for medium and low temperature refrigeration applications. The condensing units are optimized to work with HFC refrigerant R-404A, a reliable alternative to HCFC R-22. As the energy efficiency trend increases, the use of scroll compressors is a more important feature than ever before. Scroll compressors are inherently more reliable because they have significantly fewer moving parts and handle liquid slugs and debris more effectively. The scroll technology has only three moving parts, as compared to the standard hermetic compressors that have 150 plus moving parts. Scroll is effective in using less energy or amp draws verses the standard hermetic compressor. Copeland studies indicate that up to a 15% reduction in energy use is experienced for most applications. When adding the benefit of PSC motors on condensers and EC motors for evaporators, energy use will decrease. Sizing refrigeration equipment to operate for 14 to 16 hours instead of the traditional 16 to 18 hour run time will also save energy by using less kilowatts and costing less to operate compressors and motors.

Copeland Scroll Refrigeration Compressor

Read the rest of this entry »

Energy (and money) Saving Tips for Your Walk-in

Tips for Saving on Energy Costs

Here are some ways to help you save energy costs on your walk-in cooler or freezer.

• Properly seal all penetrations in walk-in.
• Replace worn or damaged door seals.
• Install refrigeration away from doors.
• Keep condenser coils clean.
• Do not prop door open for an extended period of time.
• Add strip curtains or air curtains to your walk-in for extra protection from air infiltration when door is open.
• Make sure the lights are off when exiting the walk-in. Lights produce heat, which will cause your unit to run more to hold its optimal temperature.
• Periodically, check gaskets between panels to make sure they are not cracked or weathered. If so, check with your local health codes for the correct procedure to follow as far as repair and replacement.
• Make sure there is nothing stacked around the coil to restrict airflow.
• Make sure fan motors are balanced and running at optimum speed. Clean fan blades to reduce drag.
• Use an evaporator with an EC Motor.
• Utilize Smart Defrost Kits.
• Set defrost frequency at minimum requirements.